- This topic has 1 reply, 2 voices, and was last updated 6 years, 6 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
- Posts
Hi,
I just received BerryGPS-IMU and when I’m staring at how it should be connected to RasPi 3, I started to wonder how to add another I2C device to the same RasPi3.
If I’ve understood properly, BerryGPS-IMU doesn’t need pull-up resistor for I2C same way as the normal I2C devices need?
This is a bit confusing for the electronics newbie. 🙂
No pull-up needed as they are already on BerryGPS-IMU.
You just connect BerryGPS-IMU to your Pi 3 and it should work.
If you want to add another i2c device, you can connect it to the pins highlighted below. The description of the pins are printed on the PCB
Mark --OzzMaker.com --
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.