BerryGPS IMU 4 not getting fix – More than 100 Frame errors, UART RX disabled

Home Forums Forums Technical Support for BerryGPS and BerryGPS-IMU BerryGPS IMU 4 not getting fix – More than 100 Frame errors, UART RX disabled

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #17194
    liam-vlas
    Participant

    I am using the BerryGPS IMU 4 on a raspberry Pi 4 but I am unable to get a fix. I have tried a bunch of different locations including sitting on my roof for two hours and it still does not get a fix. I am getting a message:

    – GNTXT, 01, 01, 01, More than 100 frame errors, UART RX was disabled*70

     

    I am using the internal antenna and I have the board switch set to INT. I have tried using the commands to stop echo (/usr/bin/stty -F /dev/serial0 -echo) but the error message continues. I have double checked my solders for the header and they should all be good.

    Any help on what to do would be very much appreciated!

    #17195
    Mark Williams
    Keymaster

    Have you disabled the login shell on the serial?

    Mark --OzzMaker.com --

    #17196
    liam-vlas
    Participant

    Yes, I have disabled the login shell and enabled the serial hardware.

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.

Blip, blop, bloop…