BerryIMU on top of pins

Home Forums Forums Technical Support for BerryIMU BerryIMU on top of pins

Tagged: 

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #7291
    ad van der ende
    Participant

    Hi

     

    The latter one of the assembly pictures shows that the unit can be placed directly on the PI.

    The picture is not clear how to pins are connected.

    A picture of the bottom of IMU and the PI pins would be nice.

     

    Kind regards

    ad van der ende

    #7293
    Mark Williams
    Keymaster

    BerryIMU uses the following pins on the Pi
    3.3v
    GND
    SDA
    SCL

     

    Mark --OzzMaker.com --

    #7314
    ad van der ende
    Participant

    Mark,

    thanks, but I do not know how they are physically connected.

    Are the pins of the BerryIMU soldered to the PI?

    OR wire connected?

    the picture : BerryIMUProd4-600.jpg does not shows this clearly

     

     

    #7315
    Mark Williams
    Keymaster

    Int he first image below, there is a female header (at the top left). Once came with your BerryIMU.  You will need to solder this on.

    Once this has been done, you place it on top of the Pi as shown in the second image.  This will connect all the required pins and there is no more hardware changes needed.

     

    Mark --OzzMaker.com --

    #7319
    ad van der ende
    Participant

    Thanks .

     

    It is clear now!!!

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.

Blip, blop, bloop…