BerryIMU v3 and QWIIC connector

Home Forums Forums Technical Support for BerryIMU BerryIMU v3 and QWIIC connector

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #16616
    djmaxwell
    Participant

    How do I connect the IMU v3 to a Raspberry Pi 4 with the QWIIC connector? When I attach the cable to the IMU and then to the GPIO pins with the QWIIC to header block adapter, I don’t see anything on the I2C. I then soldered the pins onto the IMU and connected it to the Pi. That works fine.

     

    #16620
    Mark Williams
    Keymaster

    How are you connecting the BerryIMU to the Pi with the QWIIC connector?  Can you shot a photo?

    Mark --OzzMaker.com --

    #16664
    djmaxwell
    Participant

    I have it connected via the pins currently, but I’ll see if I can get one. I plugged the cable into the IMU ( I tried both ports on the IMU with equally unsuccessful results) and  connected it to the header block that came with it. I connected the header block to the first six pins on the Pi. I tried it both ways. Doing it one way caused the Pi to fail to start. The other way, with the connector facing out, the Pi started but running i2cdetect didn’t show anything on the i2c buss.

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.

Blip, blop, bloop…