Connecting GPS PPS pin?

Home Forums Forums Technical Support for BerryGPS and BerryGPS-IMU Connecting GPS PPS pin?

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #15794
    geoffeg
    Participant

    I got my BerryGPS-IMU V3 this week and am looking to hook up the PPS pin. Where do I wire up the T_PULSE connector (near the super cap) to?

    Thanks!

    #15795
    Mark Williams
    Keymaster

    here is a really good guide for PPS on the Pi. In the guide, GPIO18 is used

    https://www.satsignal.eu/ntp/Raspberry-Pi-NTP.html

    Mark --OzzMaker.com --

    #15796
    geoffeg
    Participant

    Thanks, but I’m still not sure if I connect a jumper wire from T_PULSE directly to the GPIO18 pin, or to EXTINT, etc? The board has a number of pins from the female header broken out near the middle of the board. Can I wire to one of those pins or do I need to go directly to the female header?

    #15797
    Mark Williams
    Keymaster

    Directly to GPIO18, like in the image below

    Mark --OzzMaker.com --

    #15798
    geoffeg
    Participant

    Thanks!

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.

Blip, blop, bloop…