Display issues with screen on pre-configured image

Home Forums Forums Technical Support for PiScreen Display issues with screen on pre-configured image

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #2777
    Mrono
    Participant

    I’m seeing issues with the screen both before booting into X and after. Attached is an image showing the issue.

    #2780
    Mark Williams
    Keymaster

    If the colours don’t look correct, try this;

    Open /etc/modules for editing

    sudo nano /etc/modules

    Look for the value of 32000000 and change it to 24000000 and reboot.

    If you still have the issue, change the above value to 16000000

    Mark --OzzMaker.com --

    #2782
    Mrono
    Participant

    What if my /etc/modules doesn’t have that value in it. All it contains is

    snd-bcm28358
    ads7846_device spio_pendown=17 x_plate_ohms=100 pressure_max=255

    Possible a pin isn’t soldered correctly? Same issue with the ribbon cable.

    On an unrelated note I wish i’d gotten the case lol

    #2785
    Mark Williams
    Keymaster

    You must have downloaded the Image from our Website.
    This is buggy.
    We are uploading a new one now.

    Mark --OzzMaker.com --

    #2786
    Mrono
    Participant

    When will that be available? Is it just using the link from the faq page?

    #2798
    Mark Williams
    Keymaster

    In is on the quick start page, here is the direct link.
    https://ozzmaker.com/piscreen/PiScreenImage-SDCard-1.6.zip

    This should work without you having to edit any files.

    Mark
    http://www.ozzmaker.com
    PiScreen TFT for the Raspberry PI

    Mark --OzzMaker.com --

Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.

Blip, blop, bloop…