Home › Forums › Forums › Technical Support for BerryGPS and BerryGPS-IMU › I can't use BerryGPS
- This topic has 7 replies, 2 voices, and was last updated 5 years, 3 months ago by Mark Williams.
- AuthorPosts
- October 17, 2017 at 8:12 pm #6908Song JackParticipant
It is my Raspberrypi.
I installed berrygps by using "berrygps-setup-guide-raspberry-pi", but it doesn't work.
How can I fix it??- This topic was modified 5 years, 3 months ago by Song Jack.
October 17, 2017 at 9:27 pm #6910Mark WilliamsKeymasterwhat is the output of gpspipe -R
Mark --OzzMaker.com --
October 18, 2017 at 12:25 pm #6916Song JackParticipantIt's the output of gpspipe -R
{"class":"VERSION","release":"3.16","rev":"3.16-4","proto_major":3,"proto_minor":11}
{"class":"DEVICES","devices":[{"class":"DEVICE","path":"/dev/serial0","activated":"2017-10-18T01:24:20.180Z","native":0,"bps":9600,"parity":"N","stopbits":1,"cycle":1.00}]}
{"class":"WATCH","enable":true,"json":false,"nmea":false,"raw":2,"scaled":false,"timing":false,"split24":false,"pps":false}October 18, 2017 at 2:02 pm #6918Mark WilliamsKeymasterUse gpsmon so you can see the NMEA sentences from the GPS.
Are you using an external antenna? If "yes" the switch needs to be in the EXT position
Have you tested it outside?
Mark --OzzMaker.com --
October 18, 2017 at 2:19 pm #6919Song JackParticipantIt's my result of 'gpsmon' but It also doesn't show meaningful data.
And I didn't test outdoor. I don't use external antenna, only use Berrygps with Raspberrypi3. Is this a problem???
October 18, 2017 at 4:08 pm #6921Mark WilliamsKeymasterOctober 19, 2017 at 11:26 pm #6923Song JackParticipantOctober 19, 2017 at 11:36 pm #6926Mark WilliamsKeymasterWas the switch on the left of the PCB in the "int" position?
And did you leave it outside for 20 minutes?
Mark --OzzMaker.com --
- AuthorPosts
- You must be logged in to reply to this topic.