IMU Not Connecting to LSM9DS1

Home Forums Forums Technical Support for BerryIMU IMU Not Connecting to LSM9DS1

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • #16021
    icrman
    Participant

    I downloaded the code from github to run the Berry IMU and it’s not connecting to either LSM9DS0 or LSM9DS1. As far as I know I don’t have to change anything in the code to get the IMU  to output anything. I checked that I connected it correctly to an Arduino I’m using and not sure what could be wrong.

    Could the unit be dead?

    #16022
    Mark Williams
    Keymaster

    Have you tried to run an i2cScanner to check if the Arduino can see the i2C addresses of the BerryIMU?

    https://playground.arduino.cc/Main/I2cScanner/

    Mark --OzzMaker.com --

    #16023
    icrman
    Participant

    Yes, I ran the i2c scanner and it said a device was found on address 0x77.

    #16024
    Mark Williams
    Keymaster

    Was there any other addresses?  it should have found 3

    Mark --OzzMaker.com --

    #16025
    icrman
    Participant

    Nope just the one.

    #16026
    Mark Williams
    Keymaster

    can you please tell me how you have it wired.  are you using 3v pin?

    Mark --OzzMaker.com --

    #16027
    icrman
    Participant

    black to ground

    white to sda

    brown to scl

    grey to 3.3V

    #16031
    Mark Williams
    Keymaster

    Thanks… that looks correct.
    you may have a faulty IMU
    Can you send an email to sales @ ozzmaker.com

    Mark --OzzMaker.com --

Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.

Blip, blop, bloop…