IMU P1 layout

Home › Forums › Forums › Technical Support for BerryIMU › IMU P1 layout

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • March 1, 2015 at 2:53 am #3591
    8thscale
    Participant

    Question: looks like P1 layout symbol is flipped? (ie pin 1 on IMU is not square.)

    My I suggest putting a photo showing the board installed on a PI?
    Sorry old habits …! Just got my unit over here in USA! Thanks

    March 1, 2015 at 3:21 pm #3594
    Mark Williams
    Keymaster

    Yes, we only discovered that after we sent out all BerryIMUs. 🙁
    However, if the instructions are followed in the quick-start guide, people shouldn’t have any issues.

    I we will add some images today of the IMU installed on a Pi.

    Mark --OzzMaker.com --

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

Blip, blop, bloop…