Home › Forums › Forums › Technical Support for BerryGPS and BerryGPS-IMU › Noob Question for setup of BerryGPS-IMU
- This topic has 2 replies, 2 voices, and was last updated 5 years, 8 months ago by Shane Rosenbrock.
- AuthorPosts
- October 2, 2017 at 8:24 am #6866Shane RosenbrockParticipant
Hi Guys,
I’m completely new to this and am trying to design a project from scratch. I have a pi zero w and a BerryGPS-IMU module.
I have followed the instructions for getting the GPS side of things working and logging GPS data and am very happy with the results. I need some help (read: very simple, step by step instructions) for setting up the IMU side of things. I’m not sure where/how to wire this up to the pi zero?
Then once wired up I would like it to be able to log the IMU sensor data to the SD card along with the GPS co-ordinates.Can anyone help me out with this? I followed the tutorial here to get the GPS logging happily, but the links to the IMU setup don’t seem to work 🙁
October 2, 2017 at 5:40 pm #6869Mark WilliamsKeymasterHi Shane
We are so sorry that the links were incorrect.
They have now been fixed.
https://ozzmaker.com/berrygps-berrygps-imu-quick-start-guide/
The guides will have instructions on example code so you can get started using the IMU sensors.
Mark --OzzMaker.com --
October 3, 2017 at 12:51 pm #6870Shane RosenbrockParticipantCool, thanks Mark – i’ll hopefully be able to get something going using those guides.
Just another couple of quick questions (pretty basic ones). To use the IMU part of the BerryGPS-IMU do I need to solder some headers to the 5 IMU pads at the bottom of the module, or does the female header (top right) provide the GPS and IMU pin out?
And finally, is there a simple way to edit the code for the GPS logging to include a timestamp (for working out speed)?
Thanks again.
- AuthorPosts
- You must be logged in to reply to this topic.