Project

Home › Forums › Forums › Technical Support for BerryGPS and BerryGPS-IMU › Project

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 30, 2021 at 6:40 am #16801
    Marco Zurita
    Participant

    Good morning, i want to buy a IMU-GPS for a project, but i have some questions before buying it.

    Can i store in a file inside the raspberry pi all the information about, pitch, roll, altitude and gps-location given by the IMU-GPS?

    To have all this information will only be necessary to put the IMU-GPS on top of the raspberry py?

    What is the highest height the IMU-GPS can give data, in case i want to put it on a plane?

     

    Thank you in advance for your time.

    June 30, 2021 at 12:22 pm #16803
    richardp
    Participant

    Yes, you can save all the data into a file onto the Raspberry Pi, you will need to create code for this.

    You can connect the BerryGPS-IMU via cables to the Raspberry pi, it doesn’t need to sit right on top.
    All the pins needed are broken out on the side of the PCB.

    The highest supported altitude is 50km

    Richard --OzzMaker.com --

    July 1, 2021 at 7:03 am #16806
    Marco Zurita
    Participant

    Ok thank you very much for your reply, how long would it take to recieve this component in Florida- United States?

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.

Blip, blop, bloop…