suggestions for using IMU GPS _and_ GSM?

Home › Forums › Forums › Technical Support for BerryGPS and BerryGPS-IMU › suggestions for using IMU GPS _and_ GSM?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 22, 2021 at 5:45 am #17048
    jimb
    Participant

    Hello, I am currently using the BerryGPS-IMU v3 in a project and I would like to add GSM… should I use the BerryGPS-GSM and the standalone BerryIMU v3. My current project uses I2C for the IMU and serial port for GPS so, it seems that this would be the most straightforward approach. Thoughts?

    October 22, 2021 at 2:03 pm #17049
    richardp
    Participant

    yes, this is correct. If you want GSM, GPS and IMU, the simplest approach would be to use BerryGPS-GSM and then the BerryIMU. The IC2 pins are broken out on the BerryGPS-GSM and you can connect the BerryIMU to these

    Richard --OzzMaker.com --

    October 23, 2021 at 2:44 am #17051
    jimb
    Participant

    Thank you! I am heading over to the shopping page now 🙂

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.

Blip, blop, bloop…