Unable to see GPS via I2C

Home › Forums › Forums › Technical Support for the OzzMaker SARA-R5 LTE-M GPS + 10DOF › Unable to see GPS via I2C

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • September 12, 2023 at 12:09 am #18491
    WibblyD
    Participant

    Hi,

     

    I’m trying to access the GPS via I2C but the address isn’t showing up when I run i2cdetect. I can see addresses 30,6a and 77 for the IMU but nothing for the GPS. I’ve jumpered the two pads on the back of the board – pic attached. (I’ve also jumpered jp1 from earlier testing without i2c).

    I followed the guide https://ozzmaker.com/accessing-gps-via-i2c-on-a-berrygps-imu/but no luck.

    I’m running the board on top of a Pi Zero W not sure if I’ve missed something somewhere?

     

    Thanks,

    Dan

     

     

    Attachments:

    1. jumpers.jpg

    September 12, 2023 at 6:47 pm #18496
    richardp
    Participant

    The I2C pins are broken out at on the bottom left in your image. Labelled SARA SDA SCL

    Richard --OzzMaker.com --

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

Blip, blop, bloop…