fox6288

Forum Replies Created

Viewing 13 posts - 1 through 13 (of 13 total)
  • Author
    Posts
  • #15846
    fox6288
    Participant

    It says it didn’t find the process, yet the gps is still going

    #15843
    fox6288
    Participant

    Lol.  Not much better.

    #15840
    fox6288
    Participant

    And the response was this

    #15837
    fox6288
    Participant

    It looks like this

    #15834
    fox6288
    Participant

    All was good and I went ahead to the ‘Viewing Meaningful GPS Data’ part.  I followed all of the instructions and it came up with this.  What does it mean?

    #15832
    fox6288
    Participant

    I restarted the pi and double checked the solder points, its scrolling now like something out of the Matrix, but it looks just like the photos that have been provided.  I will continue to go down this path and let you know the result. 🙂

    #15829
    fox6288
    Participant

    Ok.  Worst soldering job ever, but it’s a big soldering iron.

    #15826
    fox6288
    Participant

    I soldered it.  Now this is the message I am getting.  Is this correct?

    #15825
    fox6288
    Participant

    even if they are making contact? I wanted to make sure it was running properly before I made that sort of a commitment. lol

    #15822
    fox6288
    Participant

    Ugh….I thought it had automatically attached.

    #15821
    fox6288
    Participant

    Yes

    #15818
    fox6288
    Participant

    and when I do the ‘sudo killall’ it says it can’t do that, so I try and restart minicom and I get a blank box. Then I scrolled down a bit and it showed this.

    #15815
    fox6288
    Participant

    sorry. I don’t know how to crop photos yet. this is a screen grab of what I have

Viewing 13 posts - 1 through 13 (of 13 total)

Blip, blop, bloop…