Configuration Rapsberry Nano / BerryGPS IMU 3 / SIM800X GSM/GPRSHome › Forums › Forums › General discussion › Configuration Rapsberry Nano / BerryGPS IMU 3 / SIM800X GSM/GPRSThis topic has 1 reply, 2 voices, and was last updated 3 years, 9 months ago by Mark Williams.Viewing 2 posts - 1 through 2 (of 2 total)AuthorPosts December 27, 2019 at 4:43 am #13377 MrMSTParticipantHello @all,i will use the following setup…Nano / BerryGPS IMU 3 / SIM800X GSM/GPRS as a stack. I made some pictures to make it clear.At the end, I will programs a tracker for aeroplanes.Is this setup / Stack working or are there any expected problems?Thanks, best regards from Germany…MichaelAttachments:IMG_20191226_183058-scaled.jpgIMG_20191226_183104-scaled.jpg December 27, 2019 at 11:11 am #13386 Mark WilliamsKeymasterHiMy suspicion is that it will not work.I am not familiar with the WaveShare GSM hat.. But it looks like it uses the RX/TX pins of the Pi. These pins are also used buy the BerryGPS-IMU.If you need, GPS, GSM and IMU.. you can do it using BerryGPS-GSM and then add a BerryIMU.You can access the GPS using TX/RX pins and the GSM module can be access using USB. BerryGPS-GSM; Mark --OzzMaker.com -- AuthorPostsViewing 2 posts - 1 through 2 (of 2 total)You must be logged in to reply to this topic.Log In Username: Password: Keep me signed in Log In